FAO K1ng5 Lynn Canary, Cheers bud. It was a genuine question but just out of interest.

I normally just specify "polypropylene" but noticed in the Solidworks material list it has copolymer and homopolymer and wondered what the difference was. Admittedly I could have crossed to office and looked in a "New Horizon Plastics for Designers" book but I'm basically a lazy c**T.

Posted By: CB41 on May 19th 2011 at 09:19:19

Message Thread

FAO K1ng5 Lynn Canary, Cheers bud. It was a genuine question but just out of interest. (General Chat) - CB41, May 19, 09:19:19
- a lazy c**t???? (General Chat) - Cheltenham_Canary, May 19, 09:20:49
  - One has free radicals and the other controlled radicals. (General Chat) - CB41, May 19, 09:27:20
    - oh, and "i did!" (General Chat) - Cheltenham_Canary, May 19, 09:58:33
      - IN which case shouldn't you know all that already? ;-) (n/m) (General Chat) - CB41, May 19, 10:01:33
        
        I should (General Chat) - Cheltenham_Canary, May 19, 11:06:12
- I know it wasn't for my attention but really shouldn't have opened that post*nods off* (n/m) (General Chat) - Dandy Highburyman, May 19, 09:20:45
  - Well that'll larn ya (n/m) (General Chat) - CB41, May 19, 09:31:42

Reply to Message

In order to add a post to the WotB Message Board you must be a registered WotB user.

If you are not yet registered then please visit the registration page. You should ensure that their browser is setup to accept cookies.